Installation of interior doors is a fairly simple task that can be done independently. There are several practical tips that will help to correctly install the door and avoid errors affecting the convenience of using.
Interior doors are an element that is present in almost every house. They provide intimacy, a sense of comfort and peace. It is difficult to imagine without them some rooms, for example, a bathroom or toilet, especially when it comes to a house in which the whole family lives. Interior doors are also an important element of the arrangement, on which the style and appearance of the entire interior largely depends. When making a purchase decision, it is worth focusing not only on the appearance of the door, but also on the convenience of using.
Installation of interior doors
Many are trying to install interior doors on their own. Unfortunately, if you are installed incorrectly, they can creak, rub on the floor, which will not bring the desired relaxation and peace. So, how to do this work correctly and what you should know before installation?
What is worth remembering when installing the door
First of all, you should choose high -quality doors from a trusted seller, for example on the website www.Dver-K.ru and not worry that the installation of the interior door is too complicated. The market presents a wide range of interior doors that can be installed without expensive tools. A little experience is enough. Almost everyone, even a novice enthusiast with their own hands, with basic knowledge and readiness, will be able to correctly install the doors.
The installation of interior doors is mainly reduced to three simple steps:
Installation of the frame in the opening and protection against displacement, filling the cracks with mounting foam, pendants of the door leaf.
Work should start with the assembly of parts of the frame together. Typically, there are three elements - two vertical and one horizontal beam, which, depending on the type, need to be twisted or glued, not forgetting to maintain a right angle between them.
The finished frame must be inserted into the wall opening and fixed with wooden or plastic wedges so that there is a small gap between the frame and the wall, ideally 2 cm. Using the level, you need to make sure that the side and upper beams of the frame are located correctly. At this stage, there is still the opportunity to adjust their position. Then, in the opening should be placed the struts stabilizing the frame when foaming.
The next step will be the final fixation of the frame to the slope. For this, polyurethane installation foam is used, and in the case of wooden models - additional questionnaires. Typically, the curing time of this type of foam is about 24 hours.
In the case of interior doors, when access to natural moist is difficult, materials with accelerated setting, such as mounting foam, are a good solution. Thus, the risk of displacement of the frame can be avoided. This two -component polyurethane foam with low water absorption was developed for use in structures, in particular, for the installation of interior doors.
The foam increases its volume by about 30%, so it should not be filled out completely, but only by 80%. When applying foam rubber, it is required to do this pointwise with an interval of 40-50 cm (4 points on one side at the very bottom of the floor, at the very top in the corner and at the height of the loops from the side where the sash is attached to the frame, and then on the other side at the level at the level lightning).
If, when filling the gaps, the installation foam of the door seeps to the surface of the door frame, it is enough to cut it with a knife for the wallpaper after drying out. The hardened foam can be putty, plastered, covered with silicone or acrylic putty, wallpaper or painted. Thus, you can aesthetically disguise all the connections.
A homogeneous, regular and compact structure of mounting foam creates excellent:
thermal insulation, waterproofing, acoustics.
Installation foam also sticks very well both to horizontal and vertical surfaces. After hardening, it is very highly resistant to mold and fungus, as well as chemical neutrality, which does not have a negative effect on delicate building materials and attached elements.