A spokesman for a mini-vector

The quality of animal feeding, their productivity and economic well-being of the farm directly depends on the correct choice and coordinated work of the press collector.

Order a press recoil for a mini-tractor that provides high profitability of the feeding process and preparing them for storage. High performance, coherence of the process of formation of high density rolls, the main advantages of our presents.

Pressor. Main features: PRP-80/50. Characteristic: press for hay PP-80/70. Characteristic:

Pressor. The main features:

To work with the press collection, a mini-tractor with a capacity of 18 liters is enough.With. At the same time, each press collector is highly performance and forms rolls up to 80 pieces of small rolls of rolls, they can easily store them and can cope with one person, as well as conveniently transported.There is no need to use additional equipment to move them, including unloading and loading.Sound alarm announces the formation of each roll.The kit has a bobin with a twine.The mechanism regulates the rate of expending for the spacing of the sun by 4-5 times, make rolls compact and, accordingly, the costs of transportation are reduced.

In our warehouse there are two models of the chapter:

PRP-80/50 press collector. Characteristic:

The power of the aggregated tractor is 18 30 liters.With.Rolon dimensions (diameter x width) 0.5 x 0.8 m.Working speed 3-5 km \ & jacket, rolled performance 0.28-0.42 ha \ h

Press for hay PP-80/70. Characteristic:

The power of the aggregated tractor is 18 35 liters.With.Rolon dimensions (diameter x width) 0.7 x 0.8 m.Working speed 3-5 km \ & jacket, rolled performance 0.28-0.42 ha \ h

Our press chapter models make it possible to collect faster. The rolls pressed in this way must be stored in an upright position, for better air circulation. So it will be stored longer and dry faster.

The process of installing the press collector will not take much time and does not require special technical skills. The press collection on the back of the tractor, when the bunker with rolls is filled completely, sounds a sound signal that will notify the tractor operator about knitting the roll and unloading.

Connecting the press recovery to the tractor: Lower the lower tractors and set them in accordance with the lower couplings of the press collection.Insert the pins into the holes of the collection.Set up the top clutch screw to raise the selection to the height at which the spring fingers of the selection mechanism barely touch the ground.Use a universal drive shaft to connect the tractor power selection mechanism to the press collection force (shaft on the gearbox).Sucking a shut -off pin on a universal hinge.Set up the length of the universal drive shaft according to the figure.