Inverter air conditioning allows you to more accurately maintain the specified air temperature in the room. This is due to the compressor, which works constantly, but at different revolutions, and not at the “maximum car” with regular stops and launches. The inverter split system from the usual “split” is no different in appearance, the difference is only in electronic filling, so the installation of both air conditioners is identical.
Do not engage in installation on your own, even if everything is described in the instructions in detail. Firstly, this information for installers, and secondly, you are unlikely to find the necessary tools for work and the corresponding experience. So it is better to entrust the work to professionals, for example, the Euroblimat Ustanovka-Kondicionerov. We will only tell you how about everything will happen.
Standard installation
First, the place of installation of the internal and external unit is agreed with the customer. Then, on the wall, the plate of the inner block is strictly horizontally mounted, as a rule, not far from the window. After installing the plate in the load-bearing wall under a small slope to the street, a through hole with a diameter of 4-6 cm is drilled. For such hard work, a powerful punch with a drill is used.
The next stage is the mounting on the outside of the building of the brackets for the external unit. It is usually installed under the window to simplify the installation and subsequent maintenance. An external block is installed on the fixed brackets. Then it is combined with an internal block with a heat -insulated highway, inside of which there are copper tubes for the refrigerant, as well as an electric cable. The pipe is also laid here for the removal of condensate to the outside. Having finished with installation work, they include air conditioning and check its work in different modes.
Non -standard installation
The standard installation takes about three hours and its cost is voiced by the phone at once. But there are many cases when for various reasons you have to deviate from standard work, so such points are discussed on the spot. For example, when the room is combined with an insulated loggia. In this case, the installation of the internal unit is also made in the room, but the track has to be lengthened. In addition, one more drilling of the hole may be needed if the communications do not fit into the gap between the window frame and the slope.
If for some reason the installation of an external unit under the window is impossible, it is mounted on the side or from the side of the window opening. In this case, you have to use an auto-item or call the alpineer installer. Also, the “non -standard” is the fastening of the external unit on the ventilated facade, when there is an air layer and a thick heat -insulating layer under the outer trim.
The ideal option is to install the air conditioner in the room in which the repair is underway. In this case, installation is carried out in two stages, so it also belongs to non -standard. At the first stage, the external block of the split system is installed and communications are laid in a pre-made strobe. Then the builders level the walls. At the end, the installers arrive again and install the internal unit, after which they check the operation of the air conditioner.